Advertisement
(See Figure 2 for Steps 3-4: Installing Rear Panel, Fan/Disk Drive Bracket, and Side
Fan)
3. Attach prefabbed rear panel (new panel in Upgrade Kit). Panel should come with cover
plate attached, 5 grounding fingers in place, cables attached. Make sure panel is aligned with
plastic locators in card guides before tightening screws.
a. Line panel up with plastic tabs, left side first. Using a T15 Torx screwdriver, align 6
screws (4 on bottom and 2 on top of frame) with tabs, and tighten to 18 in-lbs.
b. Align 3 plasitight T10 screws in center of panel with tabs, and torque to 18 in-lbs.
4. Install fan/disk drive bracket (insert tabs into tab slots) and side fan.
a. Attach bracket to frame (4 screws), using a T10 Torx screwdriver.
b. Connect power plug to side fan and note the polarity on the cable and fan.
c. Install side fan (4 screws), using a T15 Torx screwdriver.
d. Feed cables through rear fan window.
Figure 2. Installing Rear Panel, Fan/Disk Drive Bracket, and Side Fan
HP E2479A Upgrade Procedures
16
Advertisement
