Table of Contents
Advertisement
e. On LH side of harness
connector 5E to speaker harness connector 4A
r
on harness
.
f. OPTIONAL: If Rear Speaker Kit (PN 2882876)
or Door Speaker Kit (PN 2882889) is installed,
then remove caps from connectors 5C and 5D
t
on harness
and join to corresponding rear or
door speaker connectors.
NOTE
Connectors 5C and 5D are taped to harness
breakout from factory.
g. Secure both harnesses
leg of front dash bracket using one edge clip
4B and three edge clips 5B.
h. On RH side of harness
connector 5H to speaker harness connector 4A
r
on harness
.
i. Secure both harnesses
leg of front dash bracket using one edge clip
4B and three edge clips 5B.
t
join front speaker
r
t
and
to lower LH
t
join front speaker
r
t
and
to lower RH
Instr 9927916
Rev 02 2018-07
6. Install AM/FM antenna.
See previous section, HARNESS DETAIL, for
connector identification.
a. Mark two holes on top of right front fender for
K
alignment pin
L
, both located on antenna base
Exact base location is not critical. However, if mast
tilt functionality is desired, ensure location allows
desired tilt, and that ground strap
chassis ground location. See Step c. below.
Mark center of alignment pin hole
(15 mm) REARWARD from center of mounting
L
post hole
as shown, then drill holes at
marked locations:
• 3/16 inch (5 mm) diameter hole for alignment
K
pin
• 1/2 inch (12 mm) diameter hole for mounting
L
post
IMPORTANT
Control drill depth to prevent damage to underlying
structure or components.
Page 9 of 11
NOTE
and antenna mounting post
a
.
NOTE
o
can reach
K
9/16 inch
Advertisement
Table of Contents
