Table of Contents
Advertisement
ii. Remove five push pin rivets
of dash: two at center cupholder, two at
instrument cluster, and one on underside of
dash above cupholder.
iii. Remove three push pin rivets
side of dash: two inside upper storage area
and one on underside of dash above
cupholder.
iv. Remove upper dash from vehicle and set
aside.
NOTE
HVAC vehicles: Either cut cable ties securing ducts
to vents, or leave cable ties intact and partially lift
upper dash to gain access for audio installation.
E
from LH side
F
from RH
Instr 9927916
Rev 02 2018-07
4. Install speakers and speaker harnesses.
a. Using 1/8 inch (3 mm) drill bit, drill out four
fastener dimples
penetrate panel surface and enter pre-drilled
bosses on opposite side of panel.
All holes drilled from rear (passenger) side of panel.
Forward side shown below for reference only.
Page 7 of 11
G
. Only drill deep enough to
NOTE
Advertisement
Table of Contents
