Table of Contents
Advertisement
b. Reaching down through upper dash cavity,
route spade terminals 4D and 4E on speaker
r
harness
down through hole in speaker
compartment, then secure grommet 4C in hole.
See previous section, HARNESS DETAIL, for
connector identification.
c. Join speaker harness
i. Connector 4E (1/8 inch spade, BLACK
wire) to negative (–) terminal on speaker
ii. Connector 4D (3/16 inch spade, WHITE
wire) to positive (+) terminal on speaker
d. Install LH speaker
compartment using four screws
overtighten screws.
e. Repeat Steps 4a. through d. for RH side using
y
speaker
.
5. Install head unit harness.
See previous section, HARNESS DETAIL, as well
as head unit operating instructions for connector
identification.
NOTE
r
e
to speaker
:
e
into speaker
w
. Do not
NOTE
Instr 9927916
a. Detach firewall grommet
pulling forward slightly. Cut grommet radially
from center of hole upwards, completely
through grommet wall, as shown in
care to ensure any existing wire harness
passing through grommet is not damaged.
Purpose of cutting grommet is to enable power and
signal harness
b. Route all harness components EXCEPT relay/
fuse block 5F and terminal block connector 5G
from under-hood compartment rearward
through firewall grommet
compartment.
Reinstall firewall grommet into firewall with cut
oriented at 12 o'clock position.
c. Drill out one accessory plug (1/4 inch / 6 mm)
on under-hood liner, just forward of air intake
ducts, then install relay/fuse block 5F using
attached fir tree clip.
Control drill depth to prevent damage to underlying
d. Open power cap on vehicle terminal block at
any open location, then plug in connector 5G.
Rev 02 2018-07
Page 8 of 11
H
from firewall by
NOTE
t
to pass through grommet.
H
into upper dash
IMPORTANT
structure or components.
J
. Use
Advertisement
Table of Contents
