Table of Contents
Advertisement
b. Insert threaded post and alignment pin located
a
on antenna base
fender, attach one end of ground strap
connector 11B on antenna harness
secure with STEEL nut
IMPORTANT
Do NOT remove NYLON nut pre-installed to
threaded post.
NOTE
Fender shown partially transparent for clarity.
M
c. Remove nut
from ground stud, install loose
end of ground strap
NOTE
Ground strap improves AM reception.
d. Route connector 11A on antenna harness
rearward through firewall grommet
upper dash compartment.
NOTE
Antenna will be connected to head unit in Step 9.
Coil and stow excess antenna harness length in
upper dash compartment.
through drilled holes in
o
and
s
, then
d
. Install rubber boot.
o
, then reinstall nut.
s
H
into
Instr 9927916
Rev 02 2018-07
e. Thread antenna mast
7. OPTIONAL: Install auxiliary input.
a. Gain access.
i. Remove two push pin rivets
face of control panel. Retain rivets.
ii. Rotate bottom of control panel rearward,
disengaging two side tabs
Q
upper tabs
panel.
iii. Label and disconnect electrical harnesses
from switches, sockets, or other devices in
control panel.
Page 10 of 11
i
into antenna base
N
from lower
P
, then drop two
out of slots in main dash
a
.
Advertisement
Table of Contents
