Advertisement
7.
Minimum 2 minutes rest period must be maintained after one operation cycle. At
least 30 minutes rest period must be maintained to let the appliance cool down
after three operation cycles.
8.
Turn the speed selector to "0"position and unplug the unit after processing.
Remove the blade assembly. Unlock jar by turning it in anti-clockwise away from
its base, and lift it off. Empty the processed food.
WARNING: THE BLADE BASE CAN BE DISASSEMBLED FOR CLEANING, THE
BLADES ARE EXTREMELY SHARP. HANDLE WITH CARE
CLEANING AND MAINTENANCE
NOTE: Always clean removable parts immediately after use.
WARNING: BE CAREFUL WHEN CLEANING THE PARTS. AVOID TOUCHING THE
BLADES AS THESE ARE EXTREMELY SHARP.
NEVER IMMERSE THE MAIN HOUSING IN WATER OR ANY OTHER LIQUID
1.
Always unplug the appliance before cleaning.
2.
Disassemble all removable parts before cleaning.
3.
Clean the main housing with a clean damp cloth and dry thoroughly.
Ensure that the interlock areas are free from food particles.
4.
Clean all removable parts in a dishwasher or in warm soapy water using a mild
detergent.
TIP: For a quick wash up between processing or blending. Pour a little warm water into
the chopping jar or blender jar and operate for a few seconds. Pour out the water and
rinse if necessary.
WARNING: NEVER IMMERSE THE MOTOR BASE IN WATER OR ANY OTHER
LIQUID.
WARNING: THE BLADE BASE CAN BE DISASSEMBLED FOR CLEANING, THE
BLADES ARE EXTREMELY SHARP. HANDLE WITH CARE
IMPORTANT: Dry thoroughly. Ensure the interlock area is free of food particles.
NOTE: Some food may discolour the disk stand. This is normal and will not harm
the plastic or effect the flavour of food. Rub with cloth dipped with vegetable oil to
remove discolouration.
WASTE ELECTRICAL & ELECTRONIC EQUIPMENT DIRECTIVE 2002/96/EC
(WEEE)
At the end of this products life it should not be disposed of with general
household waste.
Care should be taken to dispose of in a suitable manner in accordance with
your Local Authority regulation.
WIRING
WARNING: If the supply cord is damaged it must be replaced by the
manufacturers service agent or a similarly qualified person in order to avoid a hazard.
The wires in the mains lead of this Food Processor are coloured in accordance to the
following code:
Blue Neutral (N)
This appliance is fitted with a 3 pin plug which has a 5amp fuse fitted.
If the plug supplied is not suitable for your socket or becomes damaged, it should be
cut off and disposed of, and a suitable plug fitted as detailed below.
As the colours of the wires in the mains lead of this Food Processor may not
correspond with the colour markings identifying the terminals in your plug, proceed as
follows.
The wire, which is coloured BLUE, must be connected to the terminal in the plug which
is marked with the letter 'N' or coloured BLACK or BLUE.
The wire, which is coloured BROWN, must be connected to the terminal in the plug
which is marked with the letter 'L' or coloured RED or BROWN.
DO NOT connect either wire to the terminal in the plug which is marked with the letter
'E' or has the Earth symbol, or coloured GREEN or GREEN/YELLOW.
9
Brown live (L)
10
Advertisement
