Advertisement
Operator Should ALWAYS
1. Be familiar with sling operating controls,
procedures and warnings.
2. Make sure all connections to load are
tight and secure.
3. Maintain firm footing when operation
sling.
4. Make sure that load is free to move and
will clear all obstructions.
5. Take up slack carefully, check liad bal-
ance, lift a few inches and check load
holding action before continuing.
6. Avoid swinging of load.
7. Maek sure that all persons stay clear of
the suspended load.
8. Warn personnel of an approaching load.
9. Protect load chain from weld spatter or
other damaging contaminants.
10. Promptly report to your supervisor or re-
pair any malfunction, unusual perfor-
mance, or damage if the sling.
11. Inspect beam regularly, replace dam-
aged or worn parts, and keep appropriate
records of maintenance
Trouble Shooting
Fehler
The pipette cannot be let down
completely
The pipette does not keep the
weight
The pipette cannot be raised to
the maximum height
Raising feebly
Weight is not raised
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Operator Should
1. Never lift more than rated load.
2. Never us damaged sling or sling that is
3. Never us the beam with twisted, kinked,
4. Never lift a load if any binding prevents
5. Never allow attention to be diverted from
6. Never use beam to lift, support or
7. NEVER LIFT LOADS OVER PEOPLE!
8. Never leave a suspended load unattend-
9. Never allow sharp contact between sling
10. Nerver allow the chain or link to be used
11. Never allow the chain or link to be
12. Never attempt to lengthen the load chain
Ursache
1. air in the hydraulic system
2. vent valve soils
1. Vent valve is open
1. Oil level too low
2. Air in the hydraulic system
1. Air in the hydraulic system
2. dirty oil
3. Vent valve is open
1. Weight too highly
2. Vent valve is open
3. Oil level too low
not working correctly.
damaged or worn chain.
equal loading on all supporting chains.
operating the sling.
transport people.
ed.
and obstructions.
a as ground for welding.
touched by a live welding electrode.
or repair damaged chain.
Lösung
1. Ventilate the hydraulic system
2. Clean the vent valve
1. . Fastenings . you the valve
1. Refilling oil
2. Ventilating hydraulic system
1. Ventilating hydraulic system
2. Exchanging oil
3Fastenings . you the valve
complete
1. Reduce the weight
2. Close the valve
3. Refilling oil
Seite 12
Advertisement
