Fan Electrical Installation; Heater Electrical Installation - CHIEF Goldwell CH1015T-NGE/NGEM Installation And Operation Manual

C E N T R I F U G A L H E A T E R - C S A

Fan Electrical Installation

Connect the fan unit to the electric power source following the recommended wiring procedure
indicated in the fan manual. The electrical disconnect switch for the fan shall be sized with adequate
ampacity for the fan rating and installed in accordance with the Canadian Electrical Code Part 1 (CSA
Standard C22.1) and any local requirements.

Heater Electrical Installation

Note
: The heater is electrically interlocked with the fan electrical service.
The heater operates on 115 volt, single phase, 60 cycle power. For fans wired for 230 volt, verify that
the fan is wired with a neutral wire to the middle terminal of the fan terminal block (#2), as well as a
ground wire linked to the bottom terminal of the fan terminal block (#3) as shown. The heater power
cord is wired into the fan controls by connecting the black wire to the terminal (#1), the white wire to
terminal (#2), and the green wire to terminal (#3) of the fan terminal block, as shown. With the heater
wired into the fan circuitry, the fan must be operating before power is available to the heater.
Chief Industries, Inc. 800-359-7600 INSTALLATION - 416274 Page 25