Remove Processor Card - Sonnet HARMONi G3 Quick Start Manual

Quick Start Guide for HARMONi G3
4. Move the cables off to the sides of the logic board/drive assembly (Figure 6).
5. Locate the two screws (#2 Phillips) inside the plastic handle (Figure 6), then
remove them; set the screws aside.
6. Using the handle, carefully lift the logic board/drive assembly out of the
computer (Figure 7); when it becomes possible, use both hands to support the
assembly.
7. Set the logic board/drive assembly on a clean, flat surface, with the curved
portion of the assembly facing you (Figure 8).

Remove Processor Card

1. Unhook a long edge of the metal shield covering the processor card, then
remove it from the logic board/drive assembly (Figure 9).
2. While grasping the underside the logic board/drive assembly and the top of
the heat sink clip with one hand, use a flat blade screwdriver to carefully
unhook the heatsink clip from the processor card shield (Figure 10). Remove
the clip and set it aside.
4
screw screw
logic board/drive
assembly
Figure 6
logic
board/drive
assembly
Figure 7
board/drive
assembly
Figure 8
top shield
Figure 9
screwdriver
heat sink clip
processor
card shield
Figure 10
logic