System description
Stand-alone trailer towing operation
OptiTire
with several trailers
TM
OptiTire
with TEBS D or TEBS E
TM
16
If the trailer should be independently equipped with OptiTire
release can be carried out via telemetry or the vehicles own display. When
using the OptiTire
display, it requires a special box for splash protection
TM
or another protected installation position. The WABCO SmartBoard can be
installed as an alternative.
The driver cannot receive fault messages without OptiTire
towing vehicle is in motion.
You will find further information in the TEBS E system descriptionsee section
"Technical documents" on page 6.
Equipment of tractor/trailer combinations with more than one trailer is possible.
Tractor/trailer combinations with two trailers can still be made with wireless
connections; road trains need CAN bus connection with special ECUs.
Please contact your WABCO partner for more information.
The installation in a vehicle with TEBS D or TEBS E is simple because in this
case only pre-assembled cables need to plugged in. Other systems would
require open wiring that needs to be enclosed by protective housing.
You will find further information in the TEBS E system descriptionsee section
"Technical documents" on page 6.
, the pressure
TM
support while the
TM