Table of Contents
Advertisement
6
To Enter Filter Settings Menu Level 5 (for the Store Manager):
With no cook timers running, displays will show one of the following displays:
;
Press the
key. The left display will show
Enter password
Tip: you can skip any item below by pressing the [P] key.
6.1
Set the Filter Trigger Time:
Note: To cycle through the three separate Filter Trigger Times use the
Display will show
6.1.1
Set the Filter Trigger Time(Hour):
Using the keypad (1-0) enter the hour (00:HH) the triggered even should occur at, press the
6.1.2
Set the Filter Trigger Time(minute):
Using the keypad (1-0) enter the minutes (MM:00) the triggered even should occur at, press the
6.1.3
Set the Filter Trigger Time(AM/PM):
Uses the [0] product key to toggle AM/PM.
Use
to continue to next filter time. Repeat for the remaining F2 and F3 filter trigger times.
Note: Hours are limited to 1-12 and minutes are limited to 1-59. If a number outside this range is
entered the controller will buzz to show the acceptable range. The control will then return to the
appropriate prompt for data re-entry, for an appropriate value to be entered. AM/PM will flash to
indicate the ability to toggle. Entering a time of 00:00 will make the filter trigger time inactive.
Note: Filter Trigger Time windows may not overlap when factoring in Early Bird and Defer allowances
for each time. Trigger times cannot be set closer than the Defer Time multiplied by the number of
Deferral Counts, plus the Early Bird Time. For example, with a Deferral Time of 30 minutes, Deferral
Count of 3, an Early Bird Time of 2 hours, and an F1 filter trigger set at 1:00 PM, the next filter trigger
(F2) must be set to 4:30 PM or later (1:00 PM + (0:30 * 3) + 2:00).
, or
..
using the product keys as a numeric keypad for entry.
(default).
Page 17 of 24
Solstice I12 Cooking Computer
Pitco P/N 60149514
.
key.
L20-379 Rev 0
.
.
Advertisement
Table of Contents
