Table of Contents
Advertisement
the drive unit switches automatically to return (forced return). This is indicated by an acoustic
signal (click).
Press the pressing tongs, pressing tongs Mini together with your hand so that they can be
removed from the pressfitting together with the drive unit. Press the adapter tongs, adapter tongs
Mini together with your hand so that they can be removed from the pressing ring together with
the drive unit. Open the pressing ring by hand so that it can be pulled off the pressfitting.
3.1.2. Operating safety
On REMS Power-Press SE the pressing process is ended by releasing the safety inching switch.
A torque-dependent safety slip clutch acts additionally in both end positions of the press rollers
for the mechanical safety of the drive units. Do not needlessly stress the safety slip clutch. REMS
Power-Press SE is equipped with an electronic safety circuit which protects the drive unit against
overloading. The drive unit can be used again afterwards as a rule unless the electronic safety
circuit switches the drive unit off repeatedly at the end of the pressing. In this case the drive unit
must be inspected/repaired by an authorised REMS customer service workshop. However, if the
drive unit switches off before pressing is completed, the drive unit must be inspected/repaired
immediately by an authorised REMS customer service workshop.
The REMS Mini-Press ACC,ends the pressing operation automatically, emitting an acoustic signal
(clicking), and returns automatically (forced movement).
A perfect pressing is only produced with full closure of the pressing tongs, pressing tongs
Mini, pressing ring or pressing segment. If a visible burr is created on the pressing sleeve
when closing the pressing tongs, pressing tongs Mini, pressing ring or pressing segment,
the pressing may be faulty or leaking.
3.1.3. Working safety
To ensure safe working, the drive units are equipped with a safety inching switch. This permits
immediate switching off of the drive units at any time, particularly if a potential hazard arises. The
drive units can be switched to the return function in any position.
4. Maintenance
REMS drive units together with all the tools (e.g. pressing tongs, pressing tongs Mini, pressing
rings with adapter tongs, adapter tongs Mini, compression heads, expanding heads) and
accessories (e.g. batteries, rapid chargers) at least once a year to an authorised REMS customer
service station for inspection and repeated inspection of electrical equipment in accordance with
EN 62638:2010-08 (VDE 0702).
16
Advertisement
Table of Contents
