Operation; Working Procedure - Pegler Yorkshire REMS Mini-Press ACC Manual

Table of Contents

joint. Without pressing counterpressure by the press fitting the drive machine or pressing tongs,

pressing tongs Mini, pressing ring, adapter tongs and adapter tongs Mini will be exposed to

unnecessarily high stress.

Never press when the tong retainer bolt (1) is unlocked. Risk of fracture, flying parts can

cause serious injuries!

3. Operation

After the drive unit has been in storage for a long period of time, the overpressure valve must

be actuated first by pressing the reset button before putting back into operation. If it is stuck or

stiff, it may not be pressed. The drive unit must be handed over to an authorized REMS customer

service workshop for inspection.

3.1. Radial presses

The pressing tongs, Mini pressing tongs, pressing ring, adapter tongs and Mini adapter tongs,

especially the pressing contour of the pressing jaws or all 3 pressing segments must be checked

for damage and wear before every use. Damaged or worn pressing tongs, Mini pressing tongs,

pressing rings, adapter tongs and Mini adapter tongs may no longer be used.

There is otherwise a risk of incorrect pressing or accidents.

A trial pressing with inserted press fitting must be made with the drive unit and the respectively

used pressing tongs, Mini pressing tongs and the respectively used pressing ring with adapter

tongs or Mini adapter tongs before every use. The pressing tongs, Mini pressing tongs , the

pressing ring with adapter tongs or Mini adapter tongs must fit into the drive unit mechanically

and be properly lockable. After completing the pressing check that the pressing jaws, pressing

rings, pressing segments close fully both at their tip. Check the tightness of the connection

(observe national specifications, standards, regulations, etc.)

If during closing of the pressing tongs, pressing tongs Mini or pressing rings a marked ridge is

created on the compression sleeve, the pressing may be defective or not tight.

For preventing damages make sure to avoid operating situations like exemplarily shown in

Fig. 12 through 14, that no distortion between pressing tongs, pressing tongs Mini, pressing

rings, adapter tongs, adapter tongs Mini, fitting and drive unit occurs. Failure to do so could

lead to fracture and flying parts can cause serious injuries.

In the case of the REMS Mini-Press ACC, REMS Mini-Press 22 V ACC, REMS Akku-Press ACC and

REMS Power-Press ACC, keep the safety inching switch pressed until the pressing is finished and

the pressing tongs or pressing ring is completely closed. After completion of pressing,

Table of Contents