Noise Information; Electrical Connection - Pegler Yorkshire REMS Mini-Press ACC Manual

1.3. Weights
REMS Mini-Press ACC drive unit without battery
REMS battery Li-Ion 14.4 V, 1.5 Ah
Pressing tongs Mini (average)

1.4. Noise Information

Emission at workplace
REMS Mini-Press ACC / 22 V ACC
1.5. Vibrations
Weighted effective value of acceleration
The specified vibration emission value was measured according to a standard test method and
can be used for comparison with another power tool. The specified vibration emission value can
also be used for an initial estimation of the cut-out.
The vibration emission value may differ from the specified value during actual use of the power
tool depending on the manner in which the power tool is used. Dependent upon the actual
conditions of use (periodic duty) it may be necessary to establish safety precautions for the
protection of the operator.
2. Safety Instructions for batteries
After the drive unit has been in storage for a long period of time, the overpressure valve must be
actuated first by pressing the reset button (7) before putting back into operation. If it is stuck or
stiff, it may not be pressed. The drive unit must be handed over to an authorized REMS customer
service workshop for inspection.
The respective latest sales literature applies for the use of REMS pressing tongs, REMS Mini press-
ing tongs, REMS pressing rings with adapter tongs, REMS pressing heads and REMS expanding
heads for the different pipe connection systems, see also www.rems.de > Downloads > Product
Catalogues, Brochures. If the system manufacturer alters components of pipe connection systems
or markets new ones, their current application status must be enquired about at REMS (Fax +49
7151 17 07 - 110 or e-mail info@rems.de). Subject to change and error.

2.1. Electrical connection

Note the mains voltage! Before connecting the drive unit or the rapid charger, check whether
the voltage given on the rating plate corresponds to the mains voltage. On building sites, in a wet
environment, indoors and outdoors or under similar installation conditions, only operate the pow-
er tool on the mains with a fault current protection switch (FI switch) which interrupts the power
supply as soon as the leakage current to earth exceeds 30 mA for 200 ms.
12
LpA = 73 dB LWA = 84 dB
2.1 kg (4.5 lb)
0.3 kg (0.6 lb)
1.2 kg (2.6 lb)
K = 3 dB
< 2,5 m/s² K = 1,5 m/s²