Installing The Safety Cover; Installing The Davinci Safety Cover - Techno-Isel Educational DaVinci Setup

Installing The Safety Cover

1. Insert two 6 mm. square nuts into the top slot of the of the gantry on the
side facing the Y-axis motor. Slide one nut to the gantry's left side, and
the other nut to its right side.
2. Repeat step 1 with the two remaining 6 mm. square nuts, inserting
these nuts into the second slot (directly under the top slot). Slide
these nuts to line up with the nuts in the top slot.
3. Place the safety cover assembly over the gantry so that the body of the
cover hangs over the gantry on the side opposite the Y-axis motor and
the brackets hang over the gantry on the side facing the Y-axis motor.
4. Center the safety cover assembly on the gantry and line up the square
nuts with the holes in the brackets.
5. Place two 6 mm. washers on each of the four 6 mm. screws. Insert
the screws through the bracket holes and into the square nuts. Tighten
the screws until the safety cover is secure.
$ $ $ $ $
DO NOT OPERATE THE DAVINCI IF THE SAFETY COVER IS NOT
INSTALLED.
Diagram 4: Installing The DaVinci Safety Cover
safety cover brackets
8
safety cover
gantry
(side facing Y-axis motor)
6 mm screws