Initial Electrical Set-Up; Educational Davinci - Techno-Isel Educational DaVinci Setup

Initial Electrical Set-Up

left leg
control panel
RS2332
Diagram 3: Educational DaVinci
To make the necessary electrical connections and adjustments on the DaVinci system,
follow the steps below.
1. Connect the 9-9 pin RS232 serial cable from the 9 pin PC COM port to the RS232
port on the DaVinci. Use only the specially wired RS232 serial cable provided.
(See the Appendix A for more information.)
$ $ $ $ $
CONNECT THE END OF THE RS232 SERIAL CABLE MARKED PC/AT TO
THE PC. DO NOT SUBSTITUTE A STANDARD SERIAL CABLE FOR THE
SPECIALLY WIRED RS232 SERIAL CABLE. DOING SO MAY RESULT IN
DAMAGE TO THE DAVINCI AND/OR PC.
2. For automatic powering of the spindle by the DaVinci, plug the spindle power
cord into the socket-ended relay cord (located on the back of the DaVinci). Then,
place the plug-ended relay cord (also located on the back of the DaVinci) into a
wall outlet. Turn the spindle on. To test the automatic powering, press the
Output button at the top of the DaVinci control panel several times, turning the
spindle on and off.
3. Plug one end of the DaVinci power cord into the power connector on the rear of
the right leg of the machine. Plug the other end into a 120VAC outlet.
motor cables
right leg
emergency
stop
(front view)
Z axis
table
5
(side view)