Mounting The Cam Clamps And Clamp Bars; Mounting Cam Clamps And Clamp Bars - Techno-Isel Educational DaVinci Setup

Mounting The CAM Clamps And Clamp Bars

A
MOUNTING CAM CLAMPS (A & B)
Diagram 2: Mounting CAM Clamps And Clamp Bars
Mounting The CAM Clamps
To mount the CAM clamps, follow the instructions below.
Diagram A: For large T-slot surface on 8x12 DaVinci.
1. Place the large T-nut in the desired T-slot.
2. Bolt the CAM clamp to large T-nut as shown.
% % % % %
Use the large T-nut only. Do not use the oval nut on any large T-slot extrusion
table model. If you remove the large T-slot table from the 8x12 DaVinci, then
you will need to refer to Diagram B.
Diagram B: For 8x8 and 8x10 DaVinci models.
1. Place the oval nut in the desired T-slot.
2. Bolt the CAM clamp to oval nut, as shown.
$ $ $ $ $
Use the oval nut only. Do not use the large T-nut on the 8x8
or 8x10 DaVinci models. The large T-nut should only be used
to mount components on surfaces with large T-slots.
Mounting The Clamp Bars
To mount the clamp bars, follow the steps outlined below.
1. Mount each clamp bar by sliding four oval nuts into separate T-slots.
2. Attach the bar to the nuts with the screws provided.
B
oval nut
4
MOUNTING
CLAMP BAR