IBM Bull Escala E5-700 Manual page 99

When installation commences, do not interfere until the installation completes. A successful
installation will return an OK message. An unsuccessful installation will return a FAILED message.
If you receive an OK message, continue to the next step. If you receive a failed message, review the
smit.log file to determine why the installation failed.
9. Press F10.
10. Type: lslpp -l | grep digi
If the Digi RealPort package installed correctly, you will receive a message. The following are
examples of return messages:
v digiasync.realport.obj 3.8.7.0 COMMITTED Digi RealPort Driver
v digiasync.realport.obj 3.8.7.0 COMMITTED Digi RealPort Driver
11. After the Digi RealPort Software is installed, the user may configure the 7036-P16 onto the network,
if it is not already configured. For instructions on how to perform the network configuration, see
"Configuring the 7036-P16 into the network" on page 90.
Installing the Linux SUSE Digi RealPort software
To install the software package for the Linux SUSE environment, do the following steps:
1. Log in to the server as the root user.
2. If the CD-ROM is already inserted and mounted, then proceed to step 5.
3. Insert the CD-ROM into the CD-ROM drive.
4. Type: mount -t auto /dev/cdrom /mnt
5. Type: cp /mnt/linux/40002086_M.src.rpm /usr/src/packages/SOURCES
6. Type: umount /mnt
7. Type: cd /usr/src/linux
8. Type: make mrproper
9. Type: make oldconfig
10. Type: cd /usr/src/packages/SOURCES
11. Type: rpmbuild --rebuild 40002086_M.src.rpm
12. Type: rpm -i /usr/src/packages/RPMS/ppc64/dgrp-1.9-6.ppc64.rpm
13. Type: rpm -qa | grep dgr
If the Digi RealPort Package installed correctly, the following is an example of the return message:
dgr-1.9.6
14. After the Digi RealPort software is installed, the user may configure the 7036-P16 onto the network,
if it is not already configured. For instructions on how to perform the network configuration, see
"Configuring the 7036-P16 into the network" on page 90.
Installing the Linux Red Hat Digi RealPort software
To install the software package for the Linux Red Hat environment, do the following steps:
1. Log in to the server as the root user.
2. If the CD-ROM is already inserted and mounted, then proceed to step 5.
3. Insert the CD-ROM into the CD-ROM drive.
4. Type: mount -t auto /dev/cdrom /mnt
5. Type: cp /mnt/linux/40002086_M.src.rpm /usr/src/packages/SOURCES
6. Type: umount /mnt
7. Type: cd /usr/src/packages/SOURCES
8. Type: rpmbuild --rebuild 40002086_M.src.rpm
9. Type: rpm -i /usr/src/packages/RPMS/ppc64/dgrp-1.9-6.ppc64.rpm
Chapter 7. Managing communications devices
87