Advertisement
Shure Incorporated
Step 8: Now insert the boundary mic into the sleeve of the XLR chassis
and then tighten the 3 Allen screws on the bottom of the mic; this will cause
the mic's rubber sleeve to expand into the XLR chassis and hold it in place.
Connect the boundary mic to the PCB.
Specifications
Electrical
Transducer Type
Permanently polarized Electret Condenser
Polar Pattern
Omnidirectional
Frequency Response
40 to 18,000 Hz
Sensitivity
[1]
-42 dBV/Pa
(7.9 mV)
Maximum SPL
1 kHz at 1% THD
142 dB SPL
Impedance
200 Ω
Signal-To-Noise Ratio
[1]
64 dBV/Pa
9/12
Advertisement
