Sunbeam Intuitive EM8910 Instruction Booklet page 46

Heading
Trouble Shooting Guide continued
PROBLEM
Not enough froth when Frothing jug.
texturing the milk
The brewing unit
cannot be removed
The brewing unit
cannot be inserted
44
POSSIBLE CAUSE
During the texturing process
the milk has been over heated
and boiled.
The brewing unit is not in its
normal position.
Brewing unit is not closed
correctly.
The locking lever behind the
service door is not in the up
position.
WHAT TO DO
For best texturing results use a
stainless steel jug and if possible
refrigerate or run the jug under
cold water before use.
Start again with fresh, chilled milk.
Leave the machine switched on
and adjust the coffee bean hopper
to the pre-ground coffee position.
Then switch off the machine and
remove the brewing unit. See page
33, Removing the coffee brewing
unit.
Turn the white service lever
upwards as far as it will go. The
ejection lever will fold back and the
brewing unit closes. See page 33,
Inserting the brewing unit.
Push the locking lever upwards and
insert the brewing unit. See page
33, Inserting the brewing unit.