Presentation
B2-62
Non "ADR" independent heater
Prior to starting, make sure the suction and dis-
charge apertures are not obstructed. There
should be no objects encumbering the area re-
served for the heater unit.
Temperature regulation
Set the required temperature on thermostat
(F1).
Start-up without programming
Press button (F2).
Warning pictogram (O) appears.
The flame glow plug is supplied with voltage
and the blower runs at low speed. After about
30 seconds, combustion begins. Check that the
heater is operating correctly. The blower speed
varies according to temperature.
Heater operating time
The timer limits the heater operating time to
120 minutes.