Breville LBM200 Instruction Book page 5

• The installation of a residual
current device (safety switch)
is recommended to provide
additional safety protection
when using electrical bread
makers. It is advisable that
a safety switch with a rated
residual operating current
not exceeding 30mA be
installed in the electrical circuit
supplying the bread maker.
See your electrician for
professional advice.
• During electrical storms,
the bread maker should be
disconnected from the power
source at the wall socket to
prevent any electrical surges
that may arise during the storm
and which may inadvertently
cause damage to the bread
maker and its electronic
componentry.
• Always turn the bread maker
to the OFF position, switch off
at the power outlet and unplug
at the power outlet when the
bread maker is not in use.
• Before cleaning, always turn
the bread maker to the OFF
position, switch off at the
power outlet, unplug at the
FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
power outlet and remove the
power cord, if detachable, from
the bread maker and allow all
parts to cool.
• Do not place this bread maker
on or near a heat source, such
as hot plate, oven or heaters.
• Position the bread maker at a
minimum distance of 20cm
away from walls, curtains and
other heat or steam sensitive
materials and provide adequate
space above and on all sides for
air circulation.
CAUTION
The lid and the outer surface
may get hot when the bread
maker is operating. The
temperature of accessible
surfaces may be high when the
bread maker is operating.
WARNING
Steam vents are very hot
during baking.
5