Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Foxtech VD16-E
Summary of Contents for Foxtech VD16-E
- Page 1 Foxtech VD16-E Radio Controller User Manual 2019.09 V1.0...
- Page 2 VD16-E Radio Control System User Manual Button/Switch Types Name Type 3-Position Switch 3-Position Switch 3-Position Switch 3-Position Switch Self-return Button(self-locked/non-self-locked) Self-locking Button Self-locking Button Self-return Button(self-locked/non-self-locked) Self-centering Dial Self-centering Dial Self-return Button(self-locked/non-self-locked) Self-return Button(self-locked/non-self-locked) SD card slot Power (Power on/ off) ©...
- Page 3 VD16-E Radio Control System User Manual Standby Mode Interface Introduction Settings: Tap on the icon to enter “Transmitter Settings” menu. Sub-trim: Displays digital sub-trim value of all 4 channels. Model Name: Displays your current model after selecting a set of model data.
- Page 4 2.Make sure that VD16-E transmitter is powered off in charging. 3.VD16-E transmitter is equipped with a built-in 3000mAh Li-Po 1S battery, so please use a standard 5V/2A adapter charger. Charging time may be different using charger with different standards, please pay an attention to transmitter charging indicator in charging.
- Page 5 User Manual Receiver Voltage Connection Please select power battery as the power supply for air unit (input voltage 15-20V). In VD16-E transmitter menu, click on “System Settings-General Settings---Voltage Receiving Settings”, and you can find a real time voltage display in PWR section on the screen. And you can also set the lower limit of voltage so as to being alerted whenever the battery voltage is lower than the standard.
- Page 6 VD16-E Radio Control System User Manual How to Place Transmitter Antenna and Receiver Antenna RF Signal of Transmitter Antenna Weak signal Strong signal Strong signal How to place Transmitter Antenna © 2019 FOXTECH All Rights Reserved...
- Page 7 VD16-E Radio Control System User Manual How to place Receiver Antenna Flying at low altitude(<10m): Placing receiver antenna upward Flying at high altitude(>10m): Placing receiver antenna downward © 2019 FOXTECH All Rights Reserved...
- Page 8 VD16-E Radio Control System User Manual Steps to Set Datalink 1.Connect the UART port of air unit to flight controller datalink port with the flight controller connection cable in the package. 2.Select the right flight controller type. 3.On a mobile device, search for an external Bluetooth device, choose the one called “02A*******”, which is of ten numbers.
Need help?
Do you have a question about the VD16-E and is the answer not in the manual?
Questions and answers