To Replace Cabinet Top - Sunbeam 2571 Owner's Manual, Operating Instruction

PRE-FILTER
Figure 12
Figure 13
CONTACTS
Figure 14

TO REPLACE CABINET TOP

Replace the cabinet top by positioning over the unit.
(Figure 15) Gently slide top forward until the top drops
into place. (Figure 16) Slide top backward until flush
with the back of the unit. (Figure 17)
Operate the unit in "FAN ONLY" position for a min-
imum of one hour to insure the cell is thoroughly dry.
NOTE: An occasional "arcing" sound is normal when
C O L L E C T I N G
operating the unit immediately after cleaning
the Cell and should stop after a few minutes of
operation. If cleaning the Cell does not alleviate
excessive arcing, refer to the Troubleshooting
Section on page 5.
Figure 15
Figure 16
Figure 17