Table of Contents
Advertisement
Quick Links
Transparent Matrix Display
Beneq Oy
Olarinluoma 9
FI-02200 Espoo
Finland
Date: October 7, 2019
ELT160.60.100-07NC
Transparent Matrix
Display
ELT160.60.100-07NC
Operations Manual
Tel. +358 9 7599 530
Fax +358 9 7599 5310
lumineq@beneq.com
Document number: ED001129C
Product Specifications and
Operations Manual
VAT ID FI25115461
www.beneq.com
www.lumineq.com
Page | 1
Rev D
Advertisement
Table of Contents
Related Manuals for beneq Lumineq ELT160.60.100-07NC
Summary of Contents for beneq Lumineq ELT160.60.100-07NC
- Page 1 ELT160.60.100-07NC Product Specifications and Operations Manual Transparent Matrix Rev D Display ELT160.60.100-07NC Transparent Matrix Display Operations Manual Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530 VAT ID FI25115461 FI-02200 Espoo Fax +358 9 7599 5310 www.beneq.com Finland lumineq@beneq.com www.lumineq.com...
-
Page 2: Table Of Contents
Defects in flex/glass (bonding) contact area ................20 4.1.2 Glass surface defects ......................20 4.1.3 Breaks in the glass panel/s edge ................... 20 Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530 VAT ID FI25115461 FI-02200 Espoo Fax +358 9 7599 5310 www.beneq.com... - Page 3 Bright spots in active area: ....................21 4.1.6 Thin film defects ........................21 Description of warranty ........................21 Ordering information .......................... 21 RoHS II ............................. 21 Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530 VAT ID FI25115461 FI-02200 Espoo Fax +358 9 7599 5310 www.beneq.com...
-
Page 4: Elt160.60.100-07Nc Display
(connector at control electronics end, fixed to the glass panel end). There are four FPCs in the display, two for segment electrodes and two for row electrodes. Note All TBD items are to be specified later by Beneq Oy. Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530... -
Page 5: Installation And Handling
Virtually any abrasive or wet wiping of the display area from the electrode side will damage the display. Dust particles may be blown away with ionized dry air. Installation in clean room environment is recommended. Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530 VAT ID FI25115461... -
Page 6: Interface Cable Length
(aka. burn-in), where permanent luminance variations can be noticed in the display. If possible, turn the screen off from time to time, or use a screen saver or image inversion to avoid this. Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530... -
Page 7: Specifications
(V ). The minimum and maximum specifications in this manual should be met, without exception, to ensure the long-term reliability of the display. Beneq does not recommend operation of the display outside these specifications. Any combination or sequencing in the application or removal of V , or video signals will not result in abnormal display operation or display catastrophic failure. -
Page 8: Connectors
Samtec TCSD family of cable strips. Compatibility with non-Samtec equivalents should verified before use. Figure 1. Data/power connector in different views Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530 VAT ID FI25115461 FI-02200 Espoo Fax +358 9 7599 5310 www.beneq.com... -
Page 9: Interface Information And Protocol
Analog dimming Interface information and Protocol Beneq EL160.60.100-07NC display incorporates an SPI interface that is similar to many LCD modules. This SPI video interface provides a low-cost, flexible method for controlling display brightness and power consumption. Designers should select the chip set or embedded board that best suits their particular architecture. -
Page 10: Initial Power-Up
SS disabled between cycles Data setup time Data hold time 3.4.2 Initial Power-up The display enters a self-test mode when turned on, if the selftest pin is not grounded. Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530 VAT ID FI25115461 FI-02200 Espoo Fax +358 9 7599 5310 www.beneq.com... -
Page 11: Spi Protocol
8 bits 8 bits 8 bits Notes: (1) First bits of first row (2) Last bits of last row. N=( Number of rows/8) * Number of columns Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530 VAT ID FI25115461 FI-02200 Espoo Fax +358 9 7599 5310 www.beneq.com... -
Page 12: Write Display Block (Multiple Rows)
Command 3.5.8 Write frame frequency Command Relative Luminance 100 % 75 % 50 % 30 % Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530 VAT ID FI25115461 FI-02200 Espoo Fax +358 9 7599 5310 www.beneq.com Finland lumineq@beneq.com www.lumineq.com... -
Page 13: Self-Test Mode
Pixel size 0.8 mm x leading to fill factor 64 % 0.8 mm Pixel amount 160 rows and 60 columns Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530 VAT ID FI25115461 FI-02200 Espoo Fax +358 9 7599 5310 www.beneq.com Finland lumineq@beneq.com... -
Page 14: Dimming
For glass panel with density 2.53 kg/dm3, approx. 30 g (without FPC and electronics) Fill factor 64 % (0.8 mm pixel side with 1.0 mm pitch) Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530 VAT ID FI25115461 FI-02200 Espoo Fax +358 9 7599 5310 www.beneq.com... -
Page 15: Fi-02200 Espoo
4 mm Misc 32.1 mm wide row contact area at both sides of the active area needed for row electrode signal feed from the bottom of the display Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530 VAT ID FI25115461... -
Page 16: Fi-02200 Espoo
Product Specifications and Operations Manual ELT160.60.100-07NC Transparent Matrix Display Figure 4. Overview figure of the 160.60.100-07NC Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530 VAT ID FI25115461 FI-02200 Espoo Fax +358 9 7599 5310 www.beneq.com Finland lumineq@beneq.com www.lumineq.com Date: October 7, 2019... - Page 17 Operations Manual ELT160.60.100-07NC Transparent Matrix Display Figure 5a. Display Panel Sizes Note that the display is viewed from the thin film side, as explained in Fig 5b. Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530 VAT ID FI25115461 FI-02200 Espoo Fax +358 9 7599 5310 www.beneq.com...
-
Page 18: Flexible Printed Circuit (Fpc, Flex)
NOTE: All FPCs are bonded to the display glass in a fixed manner and they cannot be detached. Connectors are in the PCB end. Figure 6a. Row Driver FPC Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530 VAT ID FI25115461... -
Page 19: Eca Board (Electronics Board, Pcb)
Max. height of the board is approximately 18mm (from the bottom of the lowest component on the backside to the top of the highest component on the topside) Figure 7. ECA layout Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530... -
Page 20: Quality
90 % of the nominal active segment area shall be intact. • A dark area may not exceed more than 0.25 mm2 • Max. 1 per cm2 and max. 2 per glass. Beneq Oy Olarinluoma 9 Tel. +358 9 7599 530 VAT ID FI25115461 FI-02200 Espoo Fax +358 9 7599 5310 www.beneq.com... -
Page 21: Bright Spots In Active Area
This document is compiled and kept up-to-date as conscientiously as possible. Beneq cannot, however, guarantee that the data are free of errors, accurate or complete and, therefore, assumes no liability for loss or damage of any kind incurred directly or indirectly through the use of this document. The information in this document is subject to change without notice. -
Page 22: Fi-02200 Espoo
Beneq. Unless otherwise stated, all trademarks are protected under trademark laws, especially the Beneq trademarks, logos, emblems and nameplates. The patents and trademarks presented in this document are the intellectual property of Beneq Oy. Beneq and Lumineq are registered trademarks of Beneq Oy.
Need help?
Do you have a question about the Lumineq ELT160.60.100-07NC and is the answer not in the manual?
Questions and answers