Sun Microsystems 3U Installation And User Manual page 41

3. At the ok prompt, type show-nets to list the network devices on your system.
You should see the full path name of the qfe devices, similar to the following
example:
ok show-nets
a) /ssm@0,0/pci@1f,700000/pci@1/SUNW,hme@0,1
b) /ssm@0,0/pci@1b,700000/pci@3/SUNW,hme@0,1
c) /ssm@0,0/pci@19,700000/pci@3/SUNW,qfe@3,1
d) /ssm@0,0/pci@19,700000/pci@3/SUNW,qfe@2,1
e) /ssm@0,0/pci@19,700000/pci@3/SUNW,qfe@1,1
f) /ssm@0,0/pci@19,700000/pci@3/SUNW,qfe@0,1
g) /ssm@0,0/pci@19,700000/network@2
q) NO SELECTION
Enter Selection, q to quit:
4. Select the qfe device that you want to use as a boot device.
Using the show-nets command, select the letter of the device you want to use. For
example:
Enter Selection, q to quit: c
/ssm@0,0/pci@19,700000/pci@3/SUNW,qfe@3,1 has been selected.
Type ^Y ( Control-Y ) to insert it in the command line.
e.g. ok nvalias mydev ^Y
for creating devalias mydev for
/ssm@0,0/pci@19,700000/pci@3/SUNW,qfe@3,1
Note – Select only one of these qfe devices for booting.
5. At the ok prompt the type the boot command and press the Control-Y key
sequence to paste the full path name of the selected qfe device
You can either type boot and the full path name to the qfe device, or you can type
boot and press the Control-Y key sequence. In this example, the Control-Y key
sequence would be replaced by the full path name of the qfe device:
ok boot /ssm@0,0/pci@19,700000/pci@3/SUNW,qfe@3,1
6. Press the Return key to boot the system over the qfe device.
Chapter 3 Configuring Software for the Adapter 25