Hatco Flav-R-Savor Series Installation And Operating Manual page 16

OPTIONS AND ACCESSORIES
4" (102 mm) Adjustable Legs
The 4" (102 mm) adjustable legs are used to add additional
height to the unit.
1. Secure all glass sides and doors with tape. Lay the unit on
its side. NOTICE: Do not lay unit on side with control
panel.
2. Remove the four screw-type rubber feet from the corner
brackets.
Rubber
Foot
4" Leg
Installation of 4" (102 mm) Legs
3. Screw the 4" (102 mm) legs into
the holes in the middle of each
corner bracket. After all the legs
are tightened, return the unit to
its upright position. If the unit
is not level or rocks, turn the
adjustable tip of the appropriate
leg to level the unit.
Merchandising Decal
Self-adhesive merchandising decals are available to promote
food products. The decals are designed to be installed on three
(3) sides of the cabinet above the glass panels.
Decal Installation
1. Before installing decals, clean the side panels with a non-
oily cleaner, such as isopropyl alcohol (rubbing alcohol).
2. After the cleaned surfaces have dried, remove the
protective backing from the decal and apply to the panel.
3. Any air pockets or bubbles behind the sticker can be
removed by rubbing gently with a soft cloth from the
center towards the outer edges.
Decal Installation
Corner Bracket
Shorten
Lengthen
Adjustable Tip
Decal
Decorative Kits
Several decorative kits are available for all FSD models.
Installation instructions included with kits.
Top Cover Kits
Will hold a magnetic sign up to 23" (584 mm) x 5-7/8" (149 mm).
FSD-CTLH ...........Curved Hinge Header, Control Side
FSD-CUSH ..........Curved Header, Non-Control Side
Side Inset Kits
FSD-INSET1/FSDT-INSET1 ... Two Crescent Inset Panels
FSD-INSET2/FSDT-INSET2 ... Two Wave Inset Panels
Base Skirt Kits (requires 4" [102 mm] legs, not
included)
Will hold a magnetic sign up to 20" (508 mm) x 3-1/2" (89 mm).
FSD-SQB ........... Flat Front, Back, and Side Panels
FSD-1CB ............ Curved Front Panel, Flat Back Panel, and
Flat Side Panels.
FSD-2CB ............ Curved Front and Back Panels, Flat Side Panels
FSD-CTLH FSD-CUSH
FSD-
INSET1
FSDT-
INSET1
FSD-SQB
NOTE: Make sure to specify color when ordering.
Motorless Rack Coupling
The motorless rack coupling allows the stationary installation of
a circle rack or pretzel tree in cabinets that do not have a rack
motor (FSD-1X, FSDT-1X,FSD-2X, FSDT-2X).
LED Lights
LED lights are available as accessories and come in two color
output options: Warm White (standard) and Neutral White.
16
English
FSD-1CB
FSD-
INSET2
FSDT-
INSET2
FSD-2CB
Decorative Kits
Form No. FSDM-0119