Configuring Dmx Outputs; Configuring Ip Addresses - ProLights ARTNETNODE User Manual

ARTNETNoDE
9
• Press the button ENTER. The number in the lower right-hand corner of the display flashes.
• Press the buttons UP/DOWN until the desired Art-Net universe shows.
• Press the button ENTER.

3.6 CONFIGURING DMX OUTPUTS

The DMX Out ports must be configured to accept signal from either one of the DMX In ports, or from the
Art-Net source. If the DMX port is not being used it should be turned off.
The menu structure presents each DMX Out port as a DMX Output #X, where X is the DMX Out port.
To configure the DMX Out ports, do the following:
• Select the DMX Out port to configure by pressing MENU repeatedly until DMX Output #X shows in the
display.
• Press the button ENTER. The phrase in the lower right-hand corner of the display flashes.
• Press the buttons UP/DOWN until the desired DMX input source or state of the port shows.
• Press the button ENTER.

3.7 CONFIGURING IP ADDRESSES

The IP address is the address of the ARTNETNODE on the network. It must be configured if the ARTNETNODE
is being used as an Art-Net hub.
• To configure the IP Address, do the following:
• Press the button MENU repeatedly until IP Address #1 shows in the display.
• Press the button ENTER. The left-most set of 3 digits on the display flashes.
• Press the buttons UP/DOWN to change that set of numbers.
• Press the button ENTER. The next set of 3 digits on the display flashes.
• Press the buttons UP/DOWN to change that set of numbers.
• Press the button ENTER. The right-most set of 3 digits on the display flashes.
• Press the buttons UP/DOWN to change that set of numbers.
• Press the button MENU.