Configuring Net Address; Configuring Subnet Address; Configuring Universes - ProLights ARTNETNODE User Manual

8
17 DMX Output #7
DMX Output #8
18
IP Address #1
19
20 IP Address #2
21 Device ID

3.3 CONFIGURING NET ADDRESS

The Net is the address of the network on which the ARTNETNODE is operating. The Net address must be
configured if the ARTNETNODE is being used as an Art-Net hub. To configure the Net setting, do the fol-
lowing:
• Press the button MENU so many times until the display shows Net.
• Press the button ENTER, the number in the lower right-hand corner of the display flashes.
• Press the buttons UP/DOWN until the desired Net shows.
• Press the button ENTER.

3.4 CONFIGURING SUBNET ADDRESS

The Subnet is the address of the subnet of the network on which the ARTNETNODE is operating. The
Subnet address must be configured if the ARTNETNODE is being used as an Art-Net hub. To configure the
Subnet setting, do the following:
• Press the button MENU so many times until the display shows Subnet.
• Press the button ENTER, the number in the lower right-hand corner of the display flashes.
• Press the buttons UP/DOWN until the desired Subnet shows.
• Press the button ENTER.

3.5 CONFIGURING UNIVERSES

Universes are assigned to DMX Out ports when the ARTNETNODE is used as an Art-Net-to-DMX adapter.
The universes are part of the process by which the ARTNETNODE takes the Art-Net protocol and converts
it to DMX. There are 16 Art-Net universes (0–15) that can be assigned to the DMX Out ports. Any one uni-
verse can be assigned to more than one DMX Out port.
The menu structure presents each DMX Out port as <Universe #X>, where X is the DMX Out port. The Art-Net
universes are assigned by selecting a value from 0 to 15.
To assign an Art-Net universe to a DMX Out port, do the following:
• Select the DMX Out port to assign an Art-Net universe to by pressing MENU repeatedly until Universe
#X shows in the display.
ARTNETNoDE
ð
ArtNet Input
DMX #1 Input
DMX #2 Input
Without Input
ð
ArtNet Input
DMX #1 Input
DMX #2 Input
Without Input
ð
X.XXX.XXX.XXX
ð
X.XXX.XXX.XXX
ð
XXXXXXXXX
Sets the two IP addresses
Note: The addresses cannot be the same.
Shows the device ID