Table of Contents
Advertisement
Size 025-080
Open the inspection door in front of the electrical equip-
ment cubicle.
Open the cover on the electrical equipment cubicle.
The incoming power supply is routed through the cable
entry on the upper cover panel by the electrical equip-
ment cubicle on the upper level and on to the safety
switch block in the electric equipment cubicle.
At electrical equipment cubicle on the lower level,
dismantle the cover panel above the electrical equipment
cubicle. The incoming power supply is routed through the
cable entry on the upper cover panel, down to the cable
entries on the rear of the electrical equipment cubicle and
on to the safety switch block in the electric equipment
cubicle.
The cable entries on the back of the electrical equipment
cubicle are accessible by opening the inspection door on
the closest air handling unit section.
Electrical equipment cubicle on the upper level
Inspection door in front of the
electrical equipment cubicle.
Connect the incoming power supply to the safety switch
block. The wiring terminal for incoming earth is situated
right next to the safety switch.
5-core system, 400 V ±10%. Also see section 10 Technical
data.
We reserve the right to alter specifications.
Cable entries
/HC
Safety isolating switch
/HC
Possible locations of the safety
isolating switch RX/HC
Electrical equipment cubicle on the lower level
Safety switch block.
GB.RXHCF.191011
/HC
Cable entries
/HC
Cover panel (dismantled)
Safety isolating switch
Inspection door in
front of the electrical
equipment cubicle.
The power
supply is con-
nected here
Factory-fitted
cables
www.swegon.com
11
Hide quick links:
Advertisement
Table of Contents
