Installing The Batteries To The Remote; Connect Power & Antenna/Cable/Satellite; Switching On/Off; First Time Installation - Telefunken D32H278A3CW Manual

Installing the Batteries to the Remote

1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable/Satellite
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.

Switching On/Off

Connect the power cord to a power source such as a
wall socket (220-240V AC, 50 Hz).
To switch on the TV from standby mode either:
Press the Standby button, Programme +/- or a
numeric button on the remote control.
Press the side function switch on the TV until the TV
comes on from standby.
To Switch the TV Off
Press the Standby button on the remote control or
press the side function switch on the TV until the
TV switches into standby mode.
To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched into standby mode, the
standby LED can blink to indicate that features such as
Standby Search, Over Air Download or Timer is active. The
LED can also blink when you switch on the TV from standby
mode.

First Time Installation

When turned on for the first time, the "language
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Press the "
required language, press OK button to select. "First
Time Installation" appears. Use "
set the required country, and press "
select Search Type. Use "
search type. Available search types are Digital and
analog, digital only and analog only. When set, press
" " to select Teletext Language. Use "
" button to set the "Teletext Language" and select
"Scan Encrypted" using "
can set Scan Encrypted as Yes if you want to scan
coded stations.
Default PIN code can change depending on the
selected country. If you are asked to enter a PIN
code for viewing a menu option, use one of the
following codes: 4725, 0000 or 1234.
Press OK button on the remote control to continue
and the following message will be displayed on
the screen.
English - 44 -
" or " " button to highlight the
" or " " button to
" or " " to set the desired
" or "
" button to
" or "
" button. You