Dell Force10 S55 Manual page 35

Step Task (continued)
Connect the USB-A end of cable (supplied) into an available USB port on the PC
2
Connect the USB-B end of cable into the USB-B console port on the S55 (
3
Power on the S55.
4
Install necessary USB device drivers (internet connection required).
5
Contact Dell Force10 Networks Technical Support for assistance if necessary.
Open your terminal software emulation program to access the S55.
6
Using the terminal settings shown here, set the terminal connection settings.
7
• 9600 baud rate, No parity, 8 data bits, 1 stop bit, No flow control
The CLI command prompt appears (shown below) when you are connected to the S55.
8
Access the console ports | 35