Download
Share
Print this page
Dantherm HCP 10 Installation And User Manual
  1. Manuals
  2. Brands
  3. Dantherm Manuals
  4. Remote Control
  5. HCP 10
  6. Installation and user manual

Dantherm HCP 10 Installation And User Manual

Hide thumbs Also See for HCP 10:
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
Remote Control HCP 10
Installation and User Manual
Rev. 1.3
en
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the HCP 10 and is the answer not in the manual?

Questions and answers

Related Manuals for Dantherm HCP 10

Summary of Contents for Dantherm HCP 10

  • Page 1 Remote Control HCP 10 Installation and User Manual Rev. 1.3...
  • Page 2 Remote Control HCP 10 – Installation and User Manual Introduction This instruction provides the procedures for installing and using the wired Remote Control HCP 10. Caution Before you start installing, make sure that the power to the unit is switched off.

  • Page 3: Control Panel

    Put the cable from the wall through the plastic frame and click it into the socket on the Control panel. Switch the power on and check if the display on the HCP 10 lights up, and Click the Control panel on the metal frame.
  • Page 4 How to calibrate the Domestic Ventilation unit Introduction Before you can get full benefit of the Ventilation unit, you need to calibrate it. Calibration Follow the steps below to calibrate the airflows in the unit according to the values stated in the specific Service Manual for the unit: Step Action Result...

  • Page 5: Using The Control Panel

    Using the control panel Introduction This part describes how to use the remote control (HCP 10). The functionality varies depending on if any accessory is mounted. Manual fan speed When pressing this button once, the fan speed will increase one step. When reaching...
  • Page 6 Auto bypass Only available if mechanical bypass damper is mounted inside the unit, cooling and enabled in the PC tool or via remote control (HCP 10). mode Automatic bypass cooling is dependent on user settings. On remote control (HCP 10) and PC tool the following is possible: Setting the minimum outside temperature within the range ...
  • Page 7 Using the control panel, continued Filter and error This button is the alarm reset. If the LED lights up in orange it’s a warning indications indicating that the filter needs to be changed. Please see the service guide section in the Service Manual for the product to learn how to replace the filters.
  • Page 8 NotesNotes Der tages forbehold for trykfejl og ændringer Dantherm can accept no responsibility for possible errors and changes Irrtümer und Änderungen vorbehalten Dantherm n’assume aucune responsabilité pour erreurs et modifications éventuelles...