Installing Software On The Control Workstation - IBM 4-Port 10/100 Base-TX Ethernet PCI Installation And Using Manual

__ 11. If the device driver is already installed on the node, contact your service

Installing Software on the Control Workstation

Note: If your system is partitioned ; that is, there are more than one operating system
__ 1. If you are not logged into the Control Workstation as a root user, log in now. You
__ 2. Select the appropriate CD-ROM for the operating system, as follows:
__ 3. Insert the installation media into the drive of the Control Workstation.
__ 4. Transfer the files to the Control Workstation's lppsource, as follows:
__ 5. Update the SPOT (Shared Product Object Tree) by doing the following:
10
4-Port 10/100 Base-TX Ethernet PCI Adapter: Installation and Using Guide
provider to have the adapter installed.
OR
If the device driver is not installed on the node, proceed to section "Installing
Device Drivers on the SP Nodes" on page 11.
among the nodes, you may only install this adapter in nodes that have AIX 4.3.3
or later.
may also need to export the working collective. Refer to "Checking System
Prerequisites" on page 7.
v AIX 4.3.x - Additional Device Software
a. Type the following, and then press Enter.
smitty bffcreate
b. Select the input device/directory. Press F4. Then move the cursor to the
appropriate input device and press Enter.
c. Move the cursor to the SOFTWARE package to copy option and press F4
to select the software to be installed. Use the F7 key to select the following
device driver(s) at the system prompt:
devices.pci.23100020
Press Enter.
d. Move the cursor down to DIRECTORY for storing software package and
enter the appropriate lppsource destination directory:
/spdata/sys1/install/<lppsource_name>/lppsource
Use the <lppsource_name> you recorded earlier.
e. Press Enter to begin copying the files.
Note: This step may take several minutes while the directory table of
contents is updated.
a. Type the following at the system prompt:
smitty nim_res_op
The Resource Name screen displays with the following highlighted:
boot resources boot