Table of Contents
Advertisement
4. Installation continued
Step 10:
Installing the flexible duct to the solid duct.
Install the joiner to the bottom of the solid
duct and secure with screws leaving about half
of the joiner out the bottom to allow for the
flexible duct to connect to. (Refer figure 8)
Connect one end of the flexible duct to the
starting pop on the rangehood. Secure this
with some PVC duct tape. (Refer figure 9)
Pass the flexible duct through the hole in the
ceiling and connect to the solid duct. Secure
with PVC duct tape. (Refer figure 9)
If you need to install the flexible duct with
a bend do not make the bend to sharp as
this can restrict airflow. (Refer figure 10 as an
example for correct installation of bend)
Step 11
Install the rubber dektite over the solid duct.
Do not fix down at this point refer step 13.
(This can be purchased at additional cost via
our online store: www.agradefinish.com.au)
Step 12:
Install the motor to the ducting. Slide the
flange of the motor to the outside of the
ducting and level the unit. Once level screw
to the ducting. (Refer figure 11)
Step 13:
With the motor now fixed pass the power lead
from fan inside the dektite. (Refer figure 12)
Step 14:
Once cable has been placed inside dektite
finish screwing dekite down and silicone all
edges.
PAGE 5 AGF Professional 1200
Figure 8
Figure 9
Figure 11
Figure 12
Figure 10
Advertisement
Table of Contents
