Table of Contents
Advertisement
4. Installation
Step 1:
Open box and check there is no damage
to the rangehood (if there is any damage
please contact a grade finish canopies on
(03) 9355 7100). DO NOT INSTALL.
Step 2:
Mark out the centre of where you wish to
install the rangehood. (Refer figure 1)
Step 3:
Mark out the height that you rangehood is to
be installed at. (Refer figure 2)
Step 4:
Hold rangehood up to the marks
(step 2 and 3) and mark the mounting points.
(Refer figure 3)
Step 5:
Pre drill holes for mounting
Step 6:
Hang the rangehood and tighten the screws
to fix to the wall. An additional screw fixing
must now be installed to fix into a wall stud or
if a solid wall, anywhere that is appropriate,
adjacent to the provided mounting holes.
12 gauge 40mm screws are recommended
for use. Use a good quality, sharp High Speed
Steel clearance drill to make an additional hole
in the flat mounting flange. (Refer figure 4)
PAGE 3 AGF Professional 1200
Figure 1
Figure 2
NOTE: please refer
to height listed in
safety section
Figure 3
Figure 4
Advertisement
Table of Contents
