Commissioning; Safety; Safety When Putting The Device Into Operation - Lamtec F300K Series Manual

6

Commissioning

6 Commissioning
6.1

Safety

6.1.1

Safety When Putting the Device Into Operation

Danger if shock protection is not provided
There is a risk of death or very serious injury from electric shock.
 When installing the electrical accessories, do everything necessary to provide shock pro-
 You must comply with the requirements of protection class IP40 or IP54 (for use outdoors)
The fiber optic flame detector versions F300K.. IR-.. FO with IR sensors may only be used with
the LAMTEC IR Fiber optic FOR...-IR or FOF...-IR.
Exceeding the maximum permissible operating temperature
Ensure that the maximum permissible operating temperature (see the table in Section 14.1
Technical Data) is not exceeded at the installation location, in particular as a result of radiant
heat.
 Take action to ensure sufficient cooling.
 LAMTEC offers the FK30 cooling air housing.
Laying of cables
Warning to avoid damage to property
The cables are designed for a special temperature range see chapter 14.1 Technical Data
 Lay the connecting cable including its extension apart from the mains and control cables
 Avoid laying cables near the following components:
 Although the device exceeds the requirements of the applicable EMC standards, in some
DANGER!
tection.
to EN 60529.
WARNING!
NOTICE
NOTICE
(don't lay them parallel to each other).
- Ignition cables
- Ignition transformers and electric motors
- Contactors or switches and frequency converters that switch high inductive or capacitive
loads
cases by a considerable amount, proper wiring is the prerequisite for ensuring that the de-
vice and thus the entire plant operates without problems in all cases.
26