Agilent Technologies 33250A Service Manual page 86

4
Chapter 4 Calibration Procedures
+20 dB Range Flatness Adjustment
Nominal Signal
Setup Frequency
84* 5 MHz 2.8 Vrms
85* 10.1 MHz 2.8 Vrms
86* 25.1 MHz 2.8 Vrms
87* 40.1 MHz 2.8 Vrms
88* 50.1 MHz 2.8 Vrms
89* 60.1 MHz 2.8 Vrms
90* 65.1 MHz 2.8 Vrms
91* 70.1 MHz 2.8 Vrms
92* 75.1 MHz 2.8 Vrms
93* 79.9 MHz 2.8 Vrms
94* 200 kHz 2.8 Vrms
95* 500 kHz 2.8 Vrms
96* 1.5 MHz 2.8 Vrms
97* 5 MHz 2.8 Vrms
98* 10.1 MHz 2.8 Vrms
99* 25.1 MHz 2.8 Vrms
100 60.1 MHz 3.4 Vrms
101* 79.9 MHz ~3.2 Vrms
* Constants are stored after completing this setup.
3 Using the numeric keypad or knob, adjust the displayed amplitude at
each setup to match the measured amplitude (in dBm).
Select ENTER VALUE.
4 After performing setup 101:
a. If your calibration procedures require you to verify the adjustment just
made, exit the calibration menu and perform "+20 dB Range Flatness
Verification", on page 66.
b. If you are making all the adjustments and then verifying the instrument's
performance, continue with the next procedure in this chapter.
86
Amplitude
22 dBm Flatness for +20 dB, Elliptical Filter
22 dBm Flatness for +20 dB, Elliptical Filter
22 dBm Flatness for +20 dB, Elliptical Filter
22 dBm Flatness for +20 dB, Elliptical Filter
22 dBm Flatness for +20 dB, Elliptical Filter
22 dBm Flatness for +20 dB, Elliptical Filter
22 dBm Flatness for +20 dB, Elliptical Filter
22 dBm Flatness for +20 dB, Elliptical Filter
22 dBm Flatness for +20 dB, Elliptical Filter
22 dBm Flatness for +20 dB, Elliptical Filter
22 dBm Flatness for +20 dB, Linear Phase Filter
22 dBm Flatness for +20 dB, Linear Phase Filter
22 dBm Flatness for +20 dB, Linear Phase Filter
22 dBm Flatness for +20 dB, Linear Phase Filter
22 dBm Flatness for +20 dB, Linear Phase Filter
22 dBm Flatness for +20 dB, Linear Phase Filter
24 dBm Flatness reference measurement
23 dBm Flatness high frequency measurement