Dell Force10 E300 Installing And Maintaining page 54

Command
interface management port config
100m
interface management port config
10m
interface management port config
auto-negotiate
interface management port config
no auto-negotiate
interface management port config
full-duplex
interface management port config
half-duplex
interface management port config
show
show interface management
ethernet
interface management ethernet ip
address ip-address ip-address-
mask
BOOT_USER # show interface management ethernet
No IP address set for interface management ethernet 0/0!
BOOT_USER # interface management ethernet ip address 1.2.3.4 255.255.0.0
Management ethernet 0/0 IP address: 1.2.3.4 255.255.0.0
boot zero {default | primary |
secondary}
reload
Refer to the <ItalicText>FTOS Command Line Interface Reference for BOOT_USER mode commands
and commands for run-time modes.
54 | System Boot
Purpose (continued)
• Use these commands to set the speed and duplex settings for the Management
interface.The default setting is full-duplex and auto-negotiation.
• Use the interface management port config show command to
view the Management interface's physical settings.
• Use the show interface management ethernet command to display
the IP address and network mask of the management Ethernet port.
• If the show command output does not display configured IP address
information, use the interface management ethernet ip address
ip-address ip-address-mask command to set the IP address of the
Management Ethernet port for network (ftp/tftp) operating system boot.
Delete the boot configuration.
Reload software.
The autoboot program initializes and displays self-test results on the console
screen.
NOTE:
Do not press break control sequence at any time during the boot/
reboot process. Doing so causes the boot process to terminate.