IBM TURBOWAYS 622 PCI MMF ATM Installation And Using Manual page 17

Table of Contents

Advertisement

__ 8. Verify that the device driver is installed in the lppsource directory by typing the
following at the system prompt:
cd spdata/sys1/install/<lppsource_name>/lppsource
<lppsource_name> was recorded in the previous step. Once you are in this
directory, verify that the fileset is in the lppsource directory by typing the
following at the prompt:
ls devices.pci.14105e01*
If the device driver is not in the lppsource directory, proceed to section
"Installing Software on the Control Workstation" on page 10 to install the
software.
__ 9. Update the SPOT (Shared Product Object Tree) by doing the following:
__ a. Type the following at the system prompt:
smitty nim_res_op
The Resource Name screen displays with the following highlighted:
boot
__ b. Move the cursor down until the SPOT resource is highlighted. The SPOT
resource should look similar to:
spot_AIX433
The format of the spot name is: spot_<lppsource_name>.
<lppsource_name> was the name you recorded in a previous step.
__ c. When the SPOT resource is highlighted, press Enter to select this option.
The Network Install Operation to Perform screen displays with the reset
option highlighted for selection.
__ d. Move the cursor until the cust option is highlighted and press Enter to
select this option. The Customize a SPOT screen displays with the
Source of Install Images highlighted for selection.
__ e. Press F4 to display the list of installation images and select the
appropriate lppsource.
__ f. Move the cursor until the appropriate lppsource is displayed. For
example:
lppsource_AIX433
Press Enter.
__ g. Move the cursor until Fileset Names is highlighted. Type the following
fileset name:
devices.pci.14105e01*
__ h. Press Enter to start the SPOT update. This operation can take up to 15
minutes.
__ 10. Verify that the device driver is already installed by typing the following at the
system prompt:
dsh "lslpp -l devices.pci.14105e01* 2>&1" |more
resources
boot
resources
spot
resources
Chapter 4. Installing the Device Driver on the RS/6000 SP System
lpp_source
9

Advertisement

Table of Contents
loading

Table of Contents