Table Of Contents; Declaration Of Conformity; Safety Instructions - IKA A11 basic Manual

These operating instructions apply to all IKA
Contents
Declaration of conformity
Safety instructions
Correct use
Unpacking
Useful facts
Commissioning
Malfunctions and eliminating malfunctions
Maintenance and cleaning
Accessories
Warranty
Technical data
List of spare parts A 11 basic
Spare parts diagram A 11 basic

Declaration of conformity

We declare under our sole responsibility that this product corresponds to the
regulations 2014/35/EU, 2006/42/EC, 2014/30/EU and 2011/65/EU and conforms
with the standards or normative: EN 61010-1, EN 6010-2-051, EN 61326-1,
EN 60529 and EN ISO 12100.
® - S versions
(e.g. A 11 basic S 001).
Page
14
14
15
15
15
17
18
20
21
22
22
84
86

Safety instructions

In order to be able to use the appliance properly and safely, every user
must first read the operating instructions and observe the safety instruc-
EN
tions contained therein. Take care of these operating instructions and
keep them in a place where they can be accessed by everyone.
Only staff who have been trained accordingly, know the appliance and are
authorised to carry out work in this field should use this appliance.
The machine may only be opened by trained specialists - even during repairs. The
machine is to be unplugged from the mains before opening. Live parts inside the
machine may still be live for some time after unplugging from the mains.
The appliance can only be disconnected from the mains supply by pulling out the
mains plug or the connector plug. The socket for the mains cord must be easily
accessible.
Please follow the relevant safety instructions and guidelines, and occupational
health and safety regulations for use in the laboratory. When working with the mill,
the user must wear his personal protective equipment. Defective or inappropriate
protective equipment can expose the user to the risk of spurting substances.
Please make certain that the mill is not tilted when it is in operation and hold it in
place with both hands.
Please ensure that there are no parts of the body between the casing parts that
move together.
Caution: Before removing the grinding beaker, switch off the mill and wait until the
motor stops. Risk posed by trailing crushing elements (beaters or cutters).
Always switch off the appliance and disconnect the plug before cleaning or replacing
parts.
Caution: The grinding beaker, crushing elements and rotor shaft may be hot after
long grinding cycles. Allow the mill to cool down before cleaning or before changing
crushing elements.
Caution: Beware of the sharp - edged cutter in particular when changing crushing
elements and when cleaning. Always wear your personal protective equipment
(protective gloves, etc.).
Please note that wear debris from the appliance or rotating accessories can end up
in the medium to be processed. Please contact IKA
in this respect.
® should you have any questions
14