Oasis BA-5429 Installation Manual

BA-5429
BA-R-41
BA-R-51
Paradise Isle / TR(G)-S-900
Paradise Isle / TR(G)-IF-900
Geneva / TR(G)-S-200
BA--5429
Geneva 3660 / TR-S-240 R (shown)
Geneva 3660 / TR-IF-240 R/L
Styllis / BA-6036 / BA-IF-6036
Styllis / BA-6042 (shown) / BA-IF-6042
These guidelines are recommended for
the proper installation of Oasis products. A
careful review of these procedures (and any
referenced publications) before starting is
important in avoiding an improper assembly
and/or installation.
NOTE: All illustrations in this publication are
typical, and may appear different than the
actual product. Optional items may also be
shown that were not ordered on the product
being installed.
ON WHIRLPOOL EQUIPPED MODELS,
A SEPARATE SET OF INSTRUCTIONS
IS PACKED WITH THE UNIT FOR THE
WHIRLPOOL SYSTEM. READ THEM
BEFORE INSTALLING UNIT!
Special Notes to Installer
u LIFT UNIT ONLY BY THE OUTSIDE
SHELL. DO NOT HANDLE BY SYSTEM
PIPING OR COMPONENTS!
u It is the sole responsibility of the installer
to determine the requirements necessary for
compliance with all installation code require-
ments!
Alcove Style Installation
Geneva / TR(G)-IF-200 Geneva / TR-IF-270
Geneva / TR-S-240 Futura / OV(G)-S-310
Geneva / TR-IF-240 Futura / OV(G)-IF-310
Prestige / TR-S-220 Futura / OV-S-320
Prestige / TR-IF-220 Futura / OV-IF-320
Geneva / TR-S-270
BA-R-41 R/L
BA-R-51 R/L
Prestige 3466 / TR-S-220 R (shown)
Prestige 3466 / TR-IF-220 R/L
Styllis / BA-7236 (shown) / BA-IF-7236
u All paperwork packaged with the product
should be saved and presented to the home
owner upon completion of the installation!
u All published product dimensions are
for reference only. Any critical dimensions
required for installation should be taken
directly from the product being installed!
u Any independent modifications made to
the product (or any options / accessories
supplied) beyond those required for normal
installation can void all warranties! (Refer to
warranties for further information)
INSPECTION GUIDELINES
Carefully check the unit upon receipt. Notify
your supplier immediately if any questions
or problems are encountered during this
process.
DO NOT INSTALL PRODUCT
WITHOUT FIRST ADDRESSING
QUESTIONS WHICH ARISE DURING
Basic Module Check
l Check unit drain position for match to
bathroom drain location.
Styllis / BA-6036
Styllis / BA-IF-6036
Styllis / BA-6042
Styllis / BA-IF-6042
Styllis / BA-7236
Styllis / BA-IF-7236
Paradise Isle / TR(G)-S-900 (shown)
Paradise Isle / TR(G)-IF-900
Geneva 3672 / TR-S-270 R (shown)
Geneva 3672 / TR-IF-270 R/L
Futura 4272 / OV-S-320 (shown)
THE INSPECTION!
Geneva 3260 / TR(G)-S-200 R (shown)
Geneva 3260 / TR(G)-IF-200 R/L
Futura 4260 / OV(G)-S-310 R (shown)
Futura 4260 / OV(G)-IF-310 R/L
Futura 4272 / OV-IF-320
l Check unit for surface damage.
l Check unit color for coordination to other
bathroom fixtures.
Whirlpool System Check
Assembly and operational instructions are
included in a separate publication for all
whirlpool and air equipped models.
l Check for proper trim color and system
options.
INSTALLATION SITE FRAMING
Due to individual site variations, exact
guidelines for every situation cannot be
supplied. The recommended framing and
dimensional requirements shown are for a
typical application and may vary depending
on site requirements.
The dimensions shown are from the sur-
faces where the unit will be attached. This
surface can be bare studding, drywall, or
other suitable underlayment material. It is
important that the floor and all framing be
square and level. Framing should be done
using accepted materials and construction
techniques in accordance with all applicable
codes.
®
1