Advertisement
Water Supply and Drain Connections
Refer to, and follow, the assembly and
installation instructions provided with the
supply valves and drain system. Carefully
check all connections for leaks.
Finishing Guidelines
Filler strips or filler material may be required
over the framing to ensure the under lay-
ment mounts flush over the nailing flanges.
A water resistant under layment is recom-
mended surrounding the unit. Stop the
under layment 1/16 to 1/8-inch from the unit
surface, and fill the space with a continuous
bead of water resistant sealant. (Illust. 6)
NOTE: Oasis recommends a high qual-
ity silicone based sealant with a mold and
mildew resistant content.
Use care when fastening the under layment
near the unit surface to avoid damage. Seal
the under layment seams and edges, as
required, and install the finish material to
specifications.
UNIT SURFACE CARE
WARNING!
NEVER USE ABRASIVE MATERIALS,
OR ABRASIVE CLEANERS
ON THE UNIT SURFACE!
EXTREME CAUTION is urged regarding
the use of any cleaner, acid or solvent
on the unit surface.
READ AND FOLLOW PACKAGE
INSTRUCTIONS FOR ALL
PURCHASED CLEANING PRODUCTS!
Through routine use, the unit surface can
collect residues from soap, bath additives
and natural body oils. Additional deposits
can also collect from minerals or particles
found in the water. After each use, wipe the
excess water from the unit.This practice
will reduce the buildup of deposits and help
maintain the natural unit lustre.
Following a thorough surface cleaning,
an application of quality automotive wax
will help reduce major accumulations. The
actual schedule for cleaning and waxing will
depend on unit usage and water quality.
WARNING!
NEVER APPLY WAX
TO THE UNIT FLOOR!
6
Illustration 3 -
Illustration 3 -
Unit Installation
Unit Installation
Procedure
Procedure
Wall
Framing
Nailing
Flange
2. Level Tub
in Framed Area.
u Routine Cleaning: Mild, non-abrasive
cleaner specifically formulated for gelcoat
and acrylic surfaces recommended. (Rinse
surface thoroughly)
u Heavy Soap Deposits: Liquid ammonia
household cleaner, applied full strength.
(Rinse surface thoroughly)
u Stubborn Stains: Liquid household
cleaner or hydrogen peroxide applied
full strength. Place a saturated clean rag
directly on stain and let stand several hours.
(Rinse surface thoroughly)
u Hard Water Scales: Liquid scale remover
or white vinegar, applied full strength.
(Rinse surface thoroughly)
u Mold/Mildew: Liquid mildew remover or
baking soda and water paste. (Apply paste
and allow to fizz several minutes.) (Rinse
surface thoroughly)
u Construction Adhesive: Soften adhesive
with a hand held hair dryer and peel off
adhesive. (Caution is advised when using
any electrical device near water.)
For adhesive residue, apply rubbing alcohol
or nail polish remover, full strength. (Rinse
surface thoroughly)
WARNING!
BATH MATS AND OTHER ITEMS
HELD IN PLACE USING SUCTIONS
MUST BE REMOVED FROM THE UNIT
SURFACE AFTER EACH USE.
OVER AN EXTENDED PERIOD
FAILURE TO REMOVE
SUCTION ATTACHED ITEMS WILL
DAMAGE THE UNIT SURFACE.
Confirm unit is square
within the framed area.
Confirm the tub is level
along the sides and
across each end.
Illustration 4 - Securing Unit
flange at each framing member
Nailing Flange
Wall Framing
Illustration 5 - Securing Unit
Secure unit to
framing with
large headed
fasteners.
Wall
Framing
CAUTION: Protect unit surface
with a shield when fastening.
Nailing Flange
Whirlpool Access
Drill 1/8 inch hole through
Nailing Flange
Advertisement
