Programming Alarm Wake Times; Wake With Alarm Tone - Silvercrest SKRD 30 A1 Operating Instructions Manual

Handling and operation

Programming alarm wake times

The device has two alarms available. All settings for both alarms can be carried
out independently from each other. You can select whether at the programmed
time an alarm tone shall sound or the radio shall play.
NOTICE
► If, during alarm wake programming, no button is pressed for approx.
15 seconds the alarm will activate with the current settings.
Prerequisite: The device is in the operational mode clock/standby operation.
To set the wake time proceed as follows:
♦ Press the Alarm1 button
of the respective alarm is shown blinking in the display
shown above the time indicator.
♦ Set with the buttons Tune+
each button press the wake time changes by one minute. Holding down the
respective button for more than 2 seconds starts the speed setting.
♦ Press the button Dimmer/AOT
tions Mo-Fr, Sa-Su or Mo-Su. The respective selected combination is shown
above the wake time.
♦ Press and hold down the button Dimmer/AOT
switch between the weekday combinations and individual weekday setting
alternatives.
►
♦ Press the Alarm1 button
weekday combination and move to the setting of the alarm type (tone or radio).

Wake with alarm tone

Prerequisite: The device is in the operational mode clock/standby operation.
♦ To select "Alarm tone" for the respective alarm press the Alarm1 button
or the Alarm2 button
the symbol
SKRD 30 A1
and/or appears. The weekday on which this alarm is to be activated is
NOTICE
With the individual weekday setting alternative you switch between
the days of the week with the button Dimmer/AOT
several times in succession until, in the display
9
appears.
or the Alarm2 button
8
and Tune– the desired wake time. With
12
13
to switch between the weekday combina-
5
5
and/or the Alarm2 button
8
. The set wake time
9
3 and the indicator
for at least 2 seconds to
.
5
to save the set
9
8
3
GB
,
17