Disassembly; Setting Up The Device; Providing Mains Power; Vhf Wire Antenna - Silvercrest SKRD 30 A1 Operating Instructions Manual

Disassembly

GB

Setting up the device

Providing mains power

VHF wire antenna

10
♦ Press both unlocking buttons
thereby sliding, at the same time, the device forward and then remove the
device downwards.
♦ Unscrew the screws on the mounting plate
plate .
As an alternative you can stand the device on a top. So as not to cover up the
ventilation slots and the speaker
up the device it must be mounted on the stand
proceed as follows:
♦ Press both unlocking buttons
thereby, at the same time, sliding the mounting plate
the mounting plate
♦ Slide both front retaining tabs of the stand
the underside of the device.
♦ Press both rear retaining tabs of the stand
the underside of the device until the stand audibly locks into place.
♦ Find a suitable set-up location for the device (see also the section
Requirements for the set-up location).
♦ Insert the mains connection cable
day will be shown in the display
♦ Unwind the wire antenna
Setting up and connecting
on the rear panel of the device downwards,
20
on the underside of the device, when setting
18
. For assembly of the stand
on the rear panel of the device downwards
20
. The mounting plate can now be used as a stand.
power plug into a socket. The time of
16
( o'clock).
3
completely for VHF reception.
15
and remove the mounting
backwards and remove
into the rear recesses
17
into the front recesses
17
SKRD 30 A1
on
on