Appleton Mercmaster Series Installation Instructions Manual

Installation Instructions for Mercmaster
foR PRoPER And sAfE instAllAtion of this PRoduct, PlEAsE REAd thE following instRuctions.

Applications

• Marine and wet locations;
• Areas where flammable gases and vapors are present under conditions defined by the ratings below;
• Areas of low clearance, low ceiling heights, or where fixture weights must be minimized;
• non-hazardous locations where severe weather conditions, excessive moisture, dirt, dust, corrosive atmospheres, and high
ambient temperatures are encountered.

Agency Ratings

• class I, division 2, groups A, B, c, and d
• class I, Zone 2, group IIc
• class II, division 1, groups E, f, and g
• class II, division 2, groups f and g
• class III
• type 3R, 4, and 4X
• iP66 and iP67
• wet locations
• Marine outside type (salt water) NOTE: for us applications only

Product Safety

Signal Words Defined
DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury. WARNING indicates a hazardous
situation which, if not avoided, could result in death or serious injury. CAUTION indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury. NOTICE is used to address practices not related to physical injury.

Safety Instructions

WARNING: do not open or remove the luminaire with the circuit energized.
!
WARNING: do not use this luminaire on ungrounded systems. failure to ground the luminaire can result in an electric shock, which
!
may be fatal.
WARNING: do not use on ungrounded 480 Volt circuits.
!
CAUTION: do not look directly at the lEds when energized.
!
NOTICE: do not touch the lEds; touching could leave oily deposits, causing hot spots and potential premature failure.
!
NOTICE: when installing in a hazardous location, it is necessary that the globe and all conduit plugs are tightly secured and all
!
luminaire fittings (mounting hood and luminaire) are tightly secured to the lEd housing to prevent water and dust entry. the globe
should be cleaned periodically to maintain lighting efficiency.
NOTICE: this luminaire is designed for and should be installed in accordance with the national Electrical code/canadian Electrical
!
code and all applicable local codes.
Appleton • 1.800.621.1506 • www.appletonelec.com
650457-000 INSTRUCTION SHEET
LED Luminaire
™
650457-000 Rev. E 05/13 • Page 1 of 8