Advertisement
Fig 3
5) Drill Support Holes
Carefully remove the panel from the temporary support screw and, being careful not to scratch the
panel or its covers, lay it down where it will not be damaged. Drill 4 x 7.0mm holes and install the wall
plugs.
6) Attach the Panel to the Wall
Carefully re-hang the panel on the temporary screw and then attach it firmly to the wall by the four
other screws. Put the four supplied screw bushes in the mounting holes in the panel and then attach
the panel firmly to the wall by the four supplied stainless steel cross-head screws (see Fig 4). A bead
of silicon mastic can be used, if required, to cover any gaps behind the panel on uneven walls. Do not
mastic the lower end cap to the wall as this must be removed for maintenance.
Issue 4 June 2016
Horne Engineering Ltd
3
Advertisement
