Advertisement
Using the Bladeshaft Lock.
Rotation direction is indicated by an arrow on
one side of the blade. Make sure the blade
contact surfaces are clean, free of debris.
Do not over-tighten Bladeshaft Nut. Do not use
Bladeshaft Lock to tighten Arbor Nut.
Using the Bladeshaft Lock
Features
4
OPERATING PROCEDURE
ARNING: Read the Operating Procedure
completely before operating your tile saw.
Take into account the working conditions
from the health and safety point of view.
Always pay extreme care and attention to the
preparation of the machine before starting.
Remove all wrenches and tools from the
machine.
Always keeps blade guard in place.
-
ARNING: Check that the ON/OFF switch is in the
OFF position. Then connect the power cord
to a properly grounded outlet of the correct
voltage. See the decal near the power cord
for power requirements. If needed, use the
correct size three (3) conductor extension
cord to avoid excessive voltage drop. Never
-
use lamp cord type extensions. Refer to the
Recommended Extension Cords , Section 7.
The water supply should be adequate, with
-
the water clean and make certain the
LEVER IS AL AYS ABOVE THE PUMP INLET.
Do not run the water pump dry!! Unplug for
dry cutting.
-
ON
ATER
Advertisement
