Advertisement
IF ANY PARTS ARE MISSING OR DAMAGED, PLEASE
CONTACT YOUR Husqvarna CUSTOMER SERVICE
FOR INSTRUCTIONS.
Tools required:
Husqvarna®
•
Install the Cutting Head Assembly (1):
Figures 2a & 2b
See Alignment Procedures
3.
Set-up with the Torsion Spring ( ):
ater Pump Assembly (5) Set-up:
-
The water pump inlet screen must be sub-
merged in order to properly pick up water.
NOTE: THE MOTOR
NOT TO BE USED AS A GENERAL PURPOSE
CONVENIENCE OUTLET. USE FOR CONNECTION
OF THE SUPPLIED
ATER PUMP SAFETY GUIDELINES
-
Always plug the saw power cord into a GFCI
outlet when using. If a GFCI type outlet is not
available, use a plug-in type GFCI plugged
into a properly grounded outlet. Do not use
any temporary plug adapters.
-
DO NOT EVER
Installation & Removal of Cutting Blade:
Always set the Motor Switch to OFF prior to
mounting the blade.
Husqvarna®
-
Note:
ATER PUMP OUTLET IS
ATER PUMP ONLY.
-
-
Advertisement
