Storage - HOLT Eraser HGW 13 Operator's Manual

9. Make the first pass across front edge of stump, pivoting
the stump grinder from side to side in 3-6 inch passes.
10. Continue to take passes across the front edge of the
stump, taking 3-6 inches on each pass.
11. When ground level is reached, continue to grind below
the surface to the bottom of the stump where the roots
branch out.
12. Release safety bar (C) to decrease engine speed and
disengage rotor.
13. Release wheel lock and position the stump grinder beside
the new front edge of the stump.
14. Engage wheel lock.
15. Pull safety bar (C) against handle (D) to engage rotor.
This will increase engine rpm to operating speed and
engage rotor.
16. Make multiple passes over the front edge of the stump,
taking 3-6 inches on each pass.
17. Reposition stump grinder as needed until the entire stump
has been removed to below ground level.
18. Follow the roots, taking as much of the larger surface
roots as possible. If these are not removed they can, over
time, protrude from the ground in areas where there is a
heavy freeze/thaw cycle.
19. Release safety bar (C) to disengage rotor.
20. Move stump grinder away from stump to a flat surface.
21. Stop stump grinder engine.

6.3.2 Storage

Pull handle lock (A) out and flip handle over for storage.
HOLT HGW13 Stump Grinder
A
Operator's Manual | 17